Ethereum: Bfgminer no device has been revealed
As a newcomer in the world of cryptocurrency mining, the connection of Slushpool using a BFGMIER can be a little confusing if you are not familiar with the procedure. One usual problem that arises when trying to connect the BFGMIER on Slushpool shows the “USB device not detected” error.
What happens?
The “USB device is not detected” usually occurs because the miner cannot find a USB device (usually a USB controller) on your system. This may be for different reasons, including:
- USB controller is unclear or has a low power level
- USB port using another device that consumes strength
- USB device is not properly connected or configured
Solving Steps
If on your account slushpool experience the “USB device not detected” error, try these steps to solve the problem:
- Reboot Bfgminer and Slushpool : Sometimes you simply restart and restart the miner and the dishes can solve the problem.
- Check USB power levels : Make sure the USB controller has been powered properly and has enough power to operate. You can check this using a multimeter to measure the USB port exit.
- Check the USB connection device : Make sure you connect the correct USB cable to Bfgminer and Slushpool devices.
- Check conflicts with other devices : If you have another device connected to a USB (eg keyboard, mouse) on your system, try to turn it off to see if the problem has been solved.
- Update of drivers and firmware : ensure that all relevant USB controllers are updated by updating their drivers and firmware.
6
Devices Detection Settings
To help Bfgminer discovering a USB device, you can try to adjust the devices detection settings:
- Go to
Bfgminer >
General (or
Settings ).
- Look for the “USB Device Detection” setting and adjust it:
* Enable USB detection
* Use a specific USB controller (eg USB 3.0)
* Set the minimum voltage for a USB port
Following these steps and problems to solve the problem, you should be able to solve the “USB device not detected” on your account Slushpool using a BFGMIER.
additional resources
If none of the above steps solve the problem, you can try to visit the forums to support Slushpool or search the Internet for certain solutions related to the configuration of your system. In addition, you may need to contact the Bfgminer community or other mining fans to help the devices of devices and configurations of the USB controller.
I hope this article has helped you solve the “USB device not detected” on your account Slushpool using a BFGMIER!
